(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server. It can be
set from 1 to 10080 minutes.
Figure 6-40 Time Sync by NTP Server
You can click to make sure that the NTP server is connected.
If the mini PTZ camera is connected to a public network, you should use a NTP server
that has a time synchronization function, such as the server at the National Time Center (IP
Address: 210.72.145.44). If the mini PTZ camera is set in a customized network, NTP software
can be used to establish a NTP server for time synchronization.
Configuring Time Synchronization Manually
Steps:
(1) Check the Manual Time Sync radio button.
(2) Click to set the system time from the pop-up calendar.
(3) Click to save the settings.
You can also check the Sync with local time checkbox to synchronize the time of the
mini PTZ camera with the time of your computer.
Figure 6-41 Time Sync Manually
Select the Time Zone
To Next Page
Loading...
Need help?
General
