Chapter 7 Network Sengs
7.1 Congure TCP/IP Sengs
TCP/IP sengs must be properly congured before you can operate the device over a network.
Steps
1. Go to System → Network → TCP/IP .
Figure 7-1 TCP/IP Sengs
2. Congure network parameters as needed.
Note
• Check Enable DHCP to obtain IP
sengs automacally if a DHCP server is available on the
network.
• Valid MTU value range is 500 to 9676.
3. Click Apply.
7.2
Congure DDNS
You can set Dynamic DNS service for network access. Dierent DDNS modes are available: DynDNS,
PeanutHull, and NO-IP.
ATM Digital Video Recorder User Manual
59