User Manual of Network Traffic Camera revise
31
8.7 Configuring Time
You can follow the instructions in this section to configure the time synchronization
and DST settings.
Time Settings
Steps:
1. Go to Configuration > Device Configuration > System Configuration> Time.
2. Select the time zone of your region.
3. You can adjust time manually. Or you can enable NTP (National Time Protocol)
to synchronize time of your camera to the configured NTP server.
● Manual Synchronization
Steps:
1) Select Synchronization Mode as Manual Synchronization.
2) Check Device Time. The grayed out device time shows the current camera
time.
3) Click to set the system time from the pop-up calendar.
Figure 8-8 Manual Synchronization
4) (Optional) you can also check Synchronize with PC. The camera time is
synchronized with the time of your computer.
5) Click Save to save the settings.
● NTP Synchronization
To Next Page
Loading...
Need help?
General
Weight and Dimensions
