HIKVISION iDS-TCM403-A Configuration Manual

Steps
Note
●
Not all the applicaon modes support radar parameters.
●
The radar parameters vary with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Applicaon Mode .
2.
Select Applicaon Mode.
3.
Set the parameters.
Radar Type
Select the connected radar type.
Angle
The angle between the radar and the horizontal
direcon. Set it according to the actual
construcon angle. Improper angle may aect the speed detecon.
Sensivity
The higher the value is, the more sensive the radar detecon will be.
Linkage 485 No.
Select the connected RS-485 port No. of the radar.
Radar
Ecient Time
If the duraon from the me that the radar sends the detected vehicle speed to the device to
the me that the device captures the vehicle locates in the ecient me, then the radar
detected speed is valid. If not, it is invalid.
Linearity
Correcon
Adjust the radar output result according to the actual speed.
Constant Correcon
The constant correcon is to improve the accuracy of the detecon speed. It is the extra
added/minus speed value.
Note
The nal speed is calculated according to the radar output speed, the linearity correcon, and
constant correcon together. E.g., the detected speed is 80 km/h, and you set the linearity
correcon as 1.2, and the constant correcon as 5, then the nal speed is 80 km/h × 1.2 + 5 =
101 km/h. And if you do not want to make any change to the detected speed, you can set the
linearity correcon as 1, and the constant correcon as 0.
4.
Click Save.
1.5.6 Set
Violaon Recording Parameters
You can enable violaon recording and set the parameters.
Network Trac Camera Conguraon Manual
25

HIKVISION iDS-TCM403-A Specifications

General

Brand	HIKVISION
Model	iDS-TCM403-A
Category	Security Camera
Language	English