HIKVISION iDS-TCM403-A Configuration Manual

1.
Go to Conguraon → Capture → Capture Parameters → Supplement Light Parameters .
Figure 1-16 Set Supplement Light Parameters
2.
Select the I/O and set the supplement light parameters.
I/O Output Mode
Flash Light Mode
The
ash light will be triggered by the signals and output high intensity illuminaon
instantaneously. The light can pass through the windshield and help to capture the details.
Constant Light Mode
The constant light supplements light for the scene.
Output in Advance
It is the preact me [0 to 1000 μs] of the ash light, to ensure that the ash light is on when
capture is triggered.
Output Dwell Time
It is the dwell me [0 to 10000 μs] aer the ash light responds. The actual ash light
supplement
me is the result of the dwell me minus advanced me.
Eecve Status
Select the eecve status of the supplement light according to the actual condion.
High/Low
When high/low level signal is output to the supplement light, the light will
ash.
Network Trac Camera Conguraon Manual
32

HIKVISION iDS-TCM403-A Specifications

General

Brand	HIKVISION
Model	iDS-TCM403-A
Category	Security Camera
Language	English