13
Menu
2.4
Using the Channel Menu
Tuner Mode
Select Tuner Mode if you receive TV channels over the air (antenna) or through a cable
set top box. The input will be used during a channel scan.
Auto Scan Automatically scan for channels to view programming from your TV source.
DTV Manual
Scan
Allow you to make manual fine tuning adjustments of the channel under DTV mode.
When the DTV Manual Scan screen pops, select Adjust and then press the [ / ]
buttons to select the desired Channel Number. Select Start to commence the search of
that channel. When the signal has been tuned, signal strength will be displayed on the
screen.
ATV Manual
Scan
Allows you to make manual fine tuning adjustments if the channel reception is poor under
ATV mode.
• Frequency: Input the channel frequency which you desired.
• Picture System: Select the Picture System: Auto, SECAM, PAL, NTSC.
• Sound System: Select the sound system: B/G, D/K, L, I, L’, M (L only for SECAM).
Channel Edit
Display the channels:
Click to check the need to display or hide channels.
Edit the channels:
· Rename: Press the [YELLOW] button to rename the selected channels.
Setup
Picture
Sound
Channel
Network
System
About
Tuner Mode
Antenna
Auto Scan
DTV Manual Scan
ATV Manual Scan
Channel Edit
Advanced Settings
To Next Page
Loading...
Need help?
General