6
To turn your TV on or off :
1. Plug the AC power cord into a socket outlet of AC power supply.
2. When the TV is powered on, press the [ ] button on the remote control, to turn TV on or off.
1.1
Turning your TV on or off
NOTES
When your TV is in standby mode, it is still consuming power. To completely disconnect power, please
remove the mains plug from the mains socket.
If your TV does not receive an input signal for several minutes, it automatically goes into standby mode.
Select the Input Source depending on the video device you have connected to your TV.
To select the input source:
1. Turn on your TV, then press the [INPUT] button on the remote, the list of Source appears.
2. Press the [< / >] buttons to select the input source.
3. Press the [OK] button to confirm your selection.
1.2
Selecting the Input Source
Shortcuts Instructions
You can use shortcuts on the remote control for fast operation. Refer to the “ Quick Setup Guide ” for more
information.
1.3
Live TV
Channel search guide
When you select DTV as input, if no TV channels were saved before, you will be prompted to do a channel
search. Before channel tuning could start, you must specify the tune mode, Antenna or Cable. You can also
go to Full setting menu-> channel to change the channel settings.
Launch Live TV
After channel tuning is done for the first time, the screen will display Live TV operating tips, including: how to
start the channel list, how to start the PVR / T.Shift, how to start channel info and so on.
OK
BACK
Call out Channel List
Call out PVR/T.Shift
View channel info
View recent channels
View channel Info
Call out Channel List
Call out PVR/T.Shift
View recent channels
BACK
To Next Page
Loading...
Need help?
General