English
13
When cutting the workpiece which has the dimension of “*” there might be some possibility
of the lower end of the circular saw to touch with the workpiece, even if the motor head is
located at the lower limit position. Pay attention when cutting the workpiece. For further
details, refer to “PRACTICAL APPLICATIONS” on page 25. Mount the auxiliary board on
the fence surface (Refer ( ) the thickness of auxiliary board). Refer to "5. Cutting large
workpieces" on page 28 (Fig. 28).
ACCESSORIES
WARNING: Accessories for this power tool are mentioned in this Instruction Manual.
The use of any other attachment or accessory can be dangerous and
could cause injury or mechanical damage.
STANDARD ACCESSORIES
Fig. 3
OPTIONAL ACCESSORIES...sold separately
1 Extension Holder and Stopper (Code No. 324369)
2 Crown molding Vise Ass’y (Code No. 321434) (Include Crown molding Stopper (L))
3 Crown molding Stopper (L) (Code No. 321374)
4 Crown molding Stopper (R) (Code No. 321373)
NOTE: Accessories are subject to change without any obligation on the part of the
HITACHI.
2 Dust bag (1 piece)1 12" (305 mm) TCT Saw
blade (1 piece) (For wood)
For how to use, refer to
page 38.
4 17 mm BOX wrench
(1 piece)
3 Vise Assembly w/knob bolt
(1 piece)
For how to use, refer to
page 26.
(No. of teeth 60
Code No. 726100)
5 Holder (1 piece)
For how to use, refer to
page 14.
To Next Page
Loading...
Need help?
General
