NAMES AND FUNCTIONS OF EACH PART
To prevent dust from coming into the indoor unit.
Light indicator showing the operating condition.
Horizontal deflector Vertical deflector
MODEL NAME AND DIMENSIONS
Several indoor units can be connected to one outdoor unit.
You can operate only one unit or several units according to your needs.
Combination of operations:
When operation mode is selected:
You cannot operate the indoor units in the
During automatic operation
The indoor unit which is turned on first continues to
operate. Other indoor units which are turned on later
go into standby mode and the operation lamp lights.
To operate the indoor units turned on later, set the
operation mode as same as the indoor unit turned
When heating operation is automatically selected for the first indoor unit, the next indoor unit will then start to
heat. Also, if cooling or dehumidifying is automatically selected for the first indoor unit, the next indoor unit will
also start to cool or dehumidify.
Adjusting the number of indoor units:
Decrease the number of indoor
units to be operated especially
when it is very hot or very cold
or when you want to reach the
preset temperature quickly.
When an indoor unit is operated in the cooling,
heating or dehumidifying mode in one room,
the sound of refrigerant flow may be heard
from a stopped indoor unit or a stopped indoor
unit may become warm. This is because the
indoor unit returns refrigerant to the outdoor
unit to be ready for operation.
WIDTH (mm) HEIGHT (mm) DEPTH (mm)
WIDTH (mm) HEIGHT (mm) DEPTH (mm)
WIDTH (mm) HEIGHT (mm) DEPTH (mm)
RAK-15QEF, RAK-18REF, RAK-25REF, RAK-25REFC
RAK-35REF, RAK-35REFC, RAK-50REF, RAK-50REFC
NAMES AND FUNCTIONS OF EACH PART
This lamp lights when the
This lamp lights during operation.
For about 2-3 minutes after
about once an hour when frost
forms on the heat exchanger
of the outdoor unit, for 5-10
If the power stays on and the unit is not operated, power is slightly consumed in the control circuit.
The power is saved by turning off the power switch (or the circuit breaker when the power is supplied
Use this switch to start and stop when the remote
controller does not work.
By pressing the temporary switch, the operation is
When the operation is done using the temporary
switch after the power source is turned off and turn
on again, the operation is done in automatic mode.
Turn off the circuit breaker if the