English - 23 -
RS232/LAN Command Tables
AUDIO COMMANDS
Command Description Parameter Return
GETVOLUME Volume level information. no parameter #*volume level is …
HEADPHONEVOLUME
"Set headphone volume
level."
#*set headphone volume to n
GETHEADPHONEVOLUME
"Headphone volume level
information."
no parameter #*headphone volume is …
GETMUTE Get mute value on/off. no parameter
"#*MUTE OFF
or
#*MUTE ON"
SETMUTE Set mute value on/off. no parameter
"#*MUTE OFF
or
#*MUTE ON"
SETSOUNDMODE
"Set sound mode.
SETEQUSERFREQ
100Hz 10"
right)"
"#*setSoundMode() set to n
or
#*Invalid sound mode entered"
SETBALANCE Set balance value. integer n (-50 < n < 50)
"#*set balance level to n
or
#*invalid balance level entered"
GETBALANCE Get balance value. no parameter #*balance level is …
SETAVL Set AVL state. #*set avl state to n
GETAVL Get AVL state. no parameter #*avl state is …
SETDYNAMICBASS Set dynamic bass state. #*set dynamic bass state to n
SETEQUSERFREQ
Set equalizer user freq.
value for any band.
integer n -13 < n < 13
Example:
SETEQUSERFREQ 120Hz
10"
"#*setEQUserFreq() set to n or
#*Incorrect sound system
parameter entered
or
#*Incorrect equalizer mode. It
should be USER mode"
GETDIGITALOUT Get digital out. no parameter
#*digital out is pcm or #*digital
out is compressed
SETEQMODE Set equalizer mode.
"#*setEQMode() set to n
or
#*Incorrect equalizer parameter
entered"
SETDIGITALOUT Set digital out.
#*setDigitalOut() set to n OR
#*Incorrect digital out mode
parameter entered
VOLUMEUP
"Inrease Volume Level
by 1 step
(Until max volume) "
no parameter
"#*volume LEVEL is increased
to ...
or
#*You can NOT increase volume
Volume Level is …"
VOLUMEDOWN
Decrease Volume Level
by 1 step
no parameter
"#*volume LEVEL is decreased
to ..
or
#*You can NOT decrease volume
LEVEL further. Current Volume
level is ... "
To Next Page
Loading...
Need help?
General