2-4 ●Shutdown
2.4 Shutdown (no-cleaning stop)
When you press the SHUTDOWN → OK at HOME screen, the printer stops after completing its automatic
nozzle cleaning sequence. If you repeatedly activate the SHUTDOWN → OK to stop an operation,
excessive makeup will enter the printer, thereby thinning the ink or producing an unduly high ink main tank
solution level. If it is absolutely necessary to repeatedly stop the printer operation, use the following procedure.
(For detail the HOME screen, refer to “Instruction Manual”.)
TEST
STARTPRINTING
SHUTDOWN
SETTINGS
LOGIN
Shutdown Process Confirmation
Shutdown will stop the ink jet.
Solution 1. To stop the ink jet, press <OK>.
2. To stop the ink without cleaning, press <No-cleaning stop>.
No.051
CONFIRMATION
×
OK Close
No-cleaning
stop
Press SHUTDOWN at HOME screen, and the message "Shutdown Process
Confirmation" appears.
Press No-cleaning stop on the message "Shutdown Process Confirmation".
*1: Do not use the SHUTDOWN → OK to stop operation more than two successive times.
*2: When operation was stopped using SHUTDOWN → No-cleaning stop , if left in that state, the
ink will become stuck in the nozzle and cause ink stream bending, nozzle clogging, and printing
disturbance. Apply makeup to the nozzle orifice to wash it within 30 minutes after a stop to cause the
ink to eject once again.
1
2
The no-cleaning stop procedure works even while the startup sequence is being executed.
(The SHUTDOWN → OK is inoperative during the startup sequence.)
2
Press SHUTDOWN .
To Next Page
Loading...
Need help?
General
