12-2
For safety reasons, the spare parts
for heating devices must conform
with the manufacturer's instructions.
They must be installed by the manu-
facturer or an authorised representa-
tive.
Rules for greasing and oiling
• Have the swinging lever bearings greased
after every 2,000 to 3,000 kilometers driven.
• Grease the bearing spaces on the casing of
the overrunning system.
• Oil movable parts such as bolts and joints.
• Grease the movable parts of the overrunning
system after every 5,000 kilometers driven.
• Check to see that the stationary parts of the
shearing rod are not jammed.
• Clean and oil all movable and stationary parts
at regular intervals.
Coupling ball on base vehicle
Ensure that the coupling ball meets the required
dimensions and is undamaged, clean and free of
grease. When using dacromet-coated (dull silver
anti-corrosion coating) as well as lacquered cou-
pling balls, the coating must be removed com-
pletely with sandpaper (200-240 grain) so that
it does not create deposits on the friction lining.
The metal surface of the coupling ball must be
bright. A damaged or dirty coupling ball causes
increased wear of the friction linings; a greasy
one greatly diminishes the stabilization effect.
Thinning solvents or spirit are both suitable for
cleaning.
Tension ball coupler
Keep the friction linings inside the tension ball
coupler clean and free of grease (Fig. 5). When
the friction linings are dirty, the surface can be
cleaned with 200-240 grain sandpaper. Then
clean with petroleum ether or spirit. All movable
bearings and bolts are easy to grease. By regular
upkeep and maintenance of your WS 3000, you
increase its overall life span, function and safety.
12.2 Drawgear
To Next Page
Loading...
Need help?
General
