03-7
2
3
Although some campers with a
vehicle identication number ending
in F900001 to F901055 or F930001
to F930814 have a corresponding
hole pattern, this may not be used to
mount the mover H SE / H TE.
Only the Truma mover for the models
H SE and H TE may be mounted in
the existing holes.
Mounting the mover without angle
brackets
l
is not permitted.
It is not possible to mount the mover
H SE / H TE to any of the WLU mo-
dels, because the installation space
is blocked by the hot air ducts.
The Truma standard mover SE or TE
may be used as an alternative for all
vehicles where the mover H SE / H
TE may not or cannot be mounted.
Please see your Hobby dealer for
further information or to have the
complete system mounted.
3.6 Rotating stanchions
The rotating stanchions are located in the front
and rear under the camper.
Turning the rotating stanchions outward
• Park the vehicle as horizontally as possible.
• On soft ground, lay a sturdy mat or suitably
sized board under the rotating stanchions to
prevent the camper from sinking.
• Turn the rotating stanchions outward.
The rotating stanchions may only
be used for support, and not for lev-
eling out or raising.
Turning the rotating stanchions inward
• With the crank, turn the rotating stanchions
inward to the horizontal position.
To Next Page
Loading...
Need help?
General
