SERVICING YOUR GENERATOR
76
ENGINE OIL CHANGE
Drain the oil while the engine is warm to assure rapid and complete draining.
1. Open the right maintenance cover by turning its latch (see page 33).
2. Reach under the generator and remove the black rubber seal located below
the oil drain plug.
3. Place a suitable container underneath the generator to catch the used oil.
4. Remove the oil filler cap.
5. Remove the oil drain plug and sealing washer and allow the oil to drain
completely.
6. Reinstall the oil drain plug and a new sealing washer. Tighten the plug
securely.
Torque: 16.3 lbf·ft (22.1 N·m, 2.25 kgf·m)
7. Reach under the generator and reinstall the black rubber seal.
Improper disposal of engine oil can be harmful to the environment.
If you change your own oil, please dispose of the used oil properly. Do not discard
it in a trash bin, dump it on the ground, or pour it down the drain.
31Z376200.book 76 ページ ２０２０年２月１４日 金曜日 午前１０時３９分
To Next Page
Loading...
Need help?
General
