CFI System
Fuel
Pumplcont'dl"---------------------
Shut-Off Sensor Inspection
Disconnect the vacuum hoses from the
PB
sensors.
L""~VIlI\.l
the detach the fuel pump
shut-off sensor
and
PB
sensors
as
a unit.
Turn the
ON
and tilt the sensor to the left
and
The
main
and fuel pump
in
the box
should
as
the sensor tilts
56·64
degrees
Remove the pump cover bolts and the cover.
a towel around
the fuel line
and
fitting.
loosen
the fuel hose nut Slowly, then disconnect the hose.
foo;tpeig
bracket bolt, and the fuel
Removal/Installation
Disconnect the fuel pump white 2P
f':nllnll~r
the rear fender.
Remove the
pump.
located
on
Disconnect the fuel lines from the
pump.
Remove the mounting bracket.
Install
in
the reverse order of removal.
COVER
Torque values:
Fuel hose banjo nut: 28 N.m (20 tt-lb)
Footpeg bracket bolt: 60
N.m (43 tt-lb)
SEALING
MOUNT
WASHERS
BRACKETS
~
rl$)
r :
FUEL LINE
BANJO NUT
and
washers on the fittings.
fuel lines away from sharp
leaks after
installation.
NOTES:
II
Use new
II
the
corners.
II
10·32
To Next Page
Loading...
Need help?
General
