CONTROLS
Cutting Height Adjustment Knob
Lift lever must be in the TRANSPORT
position before turning cutting height knob.
Cutting height can be adjusted from
approximately 1 - 4 inches (25 - 100 mm).
When lift lever is in TRANSPORT position (lift
lever all the way back), cutting height is approximately 4 inches (100
mm).
The cutting height adjustment knob has cutting height adjustment
numbers embossed in it.
Transmission Release
This control is used to engage or
disengage the hydrostatic
transmission. When operating the
lawn tractor under its own power,
leave the control in the engaged
R
position. If you ever need to push the
lawn tractor, pull the control out and
lock it in the released position.
pimicE-
Pushing or towing the lawn tractor with the transmission release
control in the engaged position will damage the hydrostatic
transmission.
Headlight Switch
This switch is used to turn the
headlights on or off. This switch only
works when the ignition key is in the
ON position.
18
To Next Page
Loading...
Need help?
General
