MAINTENANCE
, TRANSPORT
Left-to-Right Inspection Adjustment
1.
2.
3.
4.
Move the lift lever to TRANSPORT.
Set the height adjustment knob to the 2”
(two inch) position.
Set the anti-scalp rollers to their highest
position (page 34)
Move the lift lever to the LOCKOUT
position.
5.
Rotate the left and right side blades so
they are parallel to the front axle. It is
easier if you move one blade into
position, then hold the blade belt steady
while you move the other.
6. Use a blade height measuring gauge and
measure the blade height at outer tips
(points A and B). Heights must be within
l/8 inch (3 mm) of each other. For best
results, both heights should be about 2”
(51 mm).
7.
8.
Both the left and right sides
of the mower deck can be
adjusted. Locate the
adjustment links near the
back of the mower deck.
Loosen the top or bottom nut
as required to raise or lower
a side of mower deck.
Clockwise turns raise, while
counter-clockwise turns
lowers the side height of the
mower deck.
ADJUSTMENT LINK
80
To Next Page
Loading...
Need help?
General
