Honda HR214 User Manual

3. Turn the engine switch key to START, and hold it
until the engine starts.
CAUTION: Do not use the electric starter for more
than 5 seconds. If the engine fails to start, release
the key, and wait at least 10 seconds before operat-
ing the starter again.
NOTE: If the starter does not operate, check the
circuit breaker. The yellow pin in the circuit
breaker button pops up when the circuit breaker
has tripped. Push the circuit breaker button in to
reset.
4. After the engine starts, let the engine switch return
to ON.
5. After the engine warms up, move the throttle lever
to HI. Push the ROTO-STOP lever forward to put
the cutting blade into operation.
Self-propelled type only:
Select .shift lever position 1 (slow) or 2 (fast), and
push the drive clutch lever forward to propel the
mower.
NOTE:
The throttle lever may be moved anywhere between
HI and LO to adjust engine speed during operation.
However the engine may stall if the lever is at LO
when the ROTO-STOP is engaged.
ON
CIRCUIT BREAKER ENGINE SWITCH
I
THROTTLE LEVER
I
18

Honda HR214 Specifications

General

Cutting Width	21 inches
Cutting Height Range	1 to 3 inches
Grass Bag Capacity	2.5 bushels
Deck Material	Steel
Blade Type	Single blade
Starter System	Recoil
Engine Type	4-stroke, single cylinder, air-cooled
Drive Type	Self-propelled
Fuel Capacity	0.5 gallons
Fuel Tank Capacity	0.5 gallons
Mulching Capability	Yes
Oil Capacity	0.6 quarts
Engine	Honda GCV160