BLADE REMOVAL AND INSTALLATION
If you remove the blade, use a torque wrench to reinstall. Wear heavy
gloves to protect your hands. To avoid weakening the blade, or causing
imbalance or poor cutting, the blade should be sharpened by trained staff at
an authorized Honda servicing dealer. If replacing the blade, use a Honda
genuine replacement blade or equivalent.
Removal:
1. Turn the fuel valve to the OFF position.
2. Disconnect the spark plug cap, then
tilt the mower to the right side, so the
carburetor side is up.
3. Hold the blade disc firmly, and
remove the blade disc holder bolt.
Set a flat blade screwdriver at the
engine's bolt to prevent the blade
disc from turning when removing the
blade disc holder bolt.
53
ENGINE'S
BOLT
BLADE DISC
HOLDER BOLT
BLADE DISC
FLAT BLADE
SCREWDRIVER
BLADE
DISC'S
HOLE
To Next Page
Loading...
Need help?
General
