18
Panel-Mount Type
CONTROLS AND FEATURES
FAST IDLE LEVER
MAXIMUM FAST IDLE
LOWEST POSITION
START
ON
OFF
IGNITION
SWITCH KEY
N (neutral)
Fast Idle Lever
Ignition Switch
The ignition switch controls the
ignition system and starter motor.
The fast idle lever is only needed for
starting carbureted outboard models.
The BF115A and BF130A models
use programmed fuel injection so,
this lever will not be needed for
starting.
After the engine starts and if the
outside temperature is below 41°F
(5°C), the fast idle lever can be used
to accelerate engine warm up.
The fast idle lever will not move
unless the remote control lever is in
the N (neutral) position. Conversely,
the remote control lever will not
move unless the fast idle lever is in
the lowest position.
Lower the fast idle lever to the
lowest position to decrease the fast
idle.
02/07/23 13:02:52 31ZW5601_019
To Next Page
Loading...
Need help?
General
