Fire Alarm Control Panel IQ8Control C / M
FB 798951.10.GB0 / 04.15 23
5.2 Assembling the wall housing
The housing is pre-assembled by factory delivery. For easy installation and correct assembly of the wall housing,
carry out the following assembly steps in the order described:
1
5
3
2
4
6
7
Fig. 14: Assembling the wall housing
4x wall compensation pieces
1 x Metal sheet of the base plate for shielding and the PE connection (functional earth)
1x rear panel
1x back box
1x housing contact (up to four contacts possible)
1x front frame with operating module and housing door
4x connecting screws
The Basic module is connected to the central housing’s rear metal panel via the metal spacers and
the metal screws. Without this electrically conductive connection between the Basic module and the
rear metal panel, sufficient EMC protection for the FACP is not guaranteed.
To Next Page
Loading...
Need help?
General
