13
Atm 1/2/3/4 Zones
ATM zones are omitted by entering one of the ten ATM codes (last 10
users). To select this option enter an ATM code followed by the ent
key. Use the A> key to scroll through the four ATM zone options
(ATM1 to ATM4) and select by pressing the ent key. A preprogrammed
ATM delay time will expire before omitting all ATM zones with the
selected ATM zone type. The zones will be omitted for the duration of
the ATM time-out period and the remaining time in minutes will be
displayed on the initiating keypad. A warning is given ten and five
minutes before the zones are reinstated. The ATM Time-out period
can be extended by entering an ATM code and selecting 1=Reset
Access. To manually reinstate ATM zones, enter an ATM code and
select 2=Abort Access.
Forced Set (User Type 2.3 and Above)
Purpose
When enabled, the Forced Set option allows the user to automatically
omit zones, eligible for omission, which are open when the system
setting routine is started. Zones omitted in this way remain omitted for
one set period only.
Selecting Forced Set
Access the QUICK MENU. Press key 1 followed by the ent key. The
display indicates how many zones have been omitted and the number
of seconds left before setting.
Non-omittable Zones
Some open zones may not be eligible for omission from the system. In
this case the display indicates which zones are open and the exit time is
reset. These zones must be closed before setting can continue.
1=RESET ACCESS
2=ABORT ACCESS
ATM PIN + ent
ACCESS TIMEOUT
ATM-2 10 mins
[ent] to Select
1=ATM-1
ATM PIN + ent
[ent] to Select
2=ATM-2
>A
ent
DELAY ACCESS
ATM-2 12 mins
1
0 = OMIT ZONES
[ent] to Select
1
3 OMITTED 120
ATM PIN + ent
1 = FORCED SET
[ent] to Select
ent
2 zones open
[<] [>] to View
To Next Page
Loading...
Need help?
General
