Honeywell GSMV4G User Manual

Section 4: Registration
4-3
Possible Errors
Registration BAD
Pri ID – Need PIN
Displayed if this is a repair/replacement, or an error was made in
programming the Primary account information of the communicator
for an existing account. This prompt appears for 2 seconds. See the
Replacing an existing communicator section below for further
displays.
Registration BAD
2nd ID – Need PIN
This prompt is displayed if this is a repair/replacement, or an error
was made in programming the Secondary account information of
the communicator for an existing account. This prompt appears for
2 seconds. See the Replacing an existing communicator section
below for further displays.
Registration BAD
Pri&2nd – Need PIN
This prompt is displayed if this is a repair/replacement, or an error
was made in programming BOTH the Primary and Secondary
account information of the communicator for an existing account.
This prompt appears for 2 seconds. See the Replacing an existing
communicator section below for further displays.
Replacing an existing communicator
Enter PIN#
This prompt appears after pressing [Shift] and the down arrow
[
↓
]
on the 7720P. Enter a 4-digit alphanumeric PIN number provided
by your central station, your dealer or an authorized AlarmNet
representative.
Press the [Enter] key.
Registering …
The registration message is sent and the unit waits for
acknowledgement.
Registration
SUCCESS
If the PIN is valid, the new communicator is registered and the old
unit unregistered. Additionally, AlarmNet sends a substitution
alarm to the central station.
Registration BAD
If you entered an invalid PIN, the appropriate message is displayed
depending on which account number is being replaced (see above for
exact wording). The registration process is repeated.
NOTE: Each attempt causes a substitution alarm to be sent to the
central station.
Register by Phone
You can register the communicator by calling the AlarmNet Technical Assistance Center
(TAC) at 1-800-222-6525. You will need the following information:
• MAC number (found on the box and inside the communicator).
• Subscriber information (provided by the central station), including a city code, CSID, and
a subscriber ID.
• When instructed to do so, triple-click the tamper switch to complete the registration.

Honeywell GSMV4G Specifications

General

Brand	Honeywell
Model	GSMV4G
Category	Cell Phone
Language	English