Honeywell GSMX4G User Manual

GSMX4G / GSMXCN4G Installation and Setup Guide
– 31 –
GSM Status Displays
[E]
Operating with 3G/4G service
PriRSSI 3/4G REG
-xxxdbm stat x
Status Display Screen 1
PriRSSI – Primary site RSSI level in dBm.
3/4G – Communicator is on the 3G/4G
network where “stat” can be:
Good RSSI –20 to –90 dBm
OK RSSI –91 to –99 dBm
Marginal RSSI –100 to –105 dBm
Bad RSSI –106 to –150 dBm
REG – Registration status where “x” can be:
N – Not Registered
H – Registered Home
S – Searching
D – Registration Denied
R – Registered Roaming
? – Unknown Registration State
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the last
screen.
RAT EC/NO
3G/4G -xxxxx
Status Display Screen 2
RAT – Radio Access Technology.
EC/NO – Carrier Noise Ratio (CNR)
Press the [space] key to get to the next
screen.
Press the [backspace] key to go to the
previous field.
CNtry NetW LAC
xxx xxx xxxxx
Status Display Screen 3
CNtry – Country Code
NetW – Network Code
LAC – Local area code
Press the [space] key to get to the next
screen.
Press the [backspace] key to go to the
previous field.
Cell CHan PSC
xxxxxxx xxxx xxx
Status Display Screen 4
Cell – Base Station ID
CHan – Control Channel in use
PSC – Primary Sync Code

Honeywell GSMX4G Specifications

General

Brand	Honeywell
Model	GSMX4G
Category	Cell Phone
Language	English