Performance Series IP Camera Software Configuration Guide
36
ONVIF
Figure 6-3 ONVIF
ONVIF (Open Network Video Interface Forum) is a global open standard for the interface of
IP-based security products. It covers network video mode, interface, data type, and data
interaction mode. The ONVIF specification aims at interoperability of network video products
regardless of manufacturer.
The ONVIF setting is enabled by default.
• To enable ONVIF, click ON.
• To disable ONVIF, click OFF.
Note
HTTPS is enabled by default. If your headend only supports ONVIF
HTTP, you can disable HTTPS by clearing the HTTPS Setting
check box and then clicking Save. A warning message will appear
indicating that your connection is no longer secure.
RTSP
Figure 6-4 RTSP
RTSP Over TLS: RTSP Over TLS is used to encrypt video stream transmit between browser
and device or device and headend. Click ON to enable RTSP Over TLS. The default setting is
OFF.
Configuring PPPoE Settings
Go to Setup Network Setup PPPoE.
To Next Page
Loading...
Need help?
General
