Honeywell H4W2PER3 User Manual

Performance Series IP Camera Software Configuration Guide
72
Note
If you specify a MAC address limitation here, the computer with the
specified MAC address must be in the same network subnet as the
IP camera.
CAUTION If you set up the IP Filter/ Approved Users options and forget the IP/MAC
address that is allowed to access the camera, you will have to return the camera to the
factory to repair the problem.
Restoring Default Settings
Go to Setup System Setup Default.
Figure 9-10 Default
To reset the camera, click:
• Default – Recover configurations to default except network IP address and user
management.
• Factory Default – Completely recover device parameters to factory default.
A confirmation message appears. Click OK to continue. The camera reboots automatically
and reverts to its factory default settings.
Import/Export
Go to Setup System Setup  Import/Export.
Figure 9-11 Import/Export Configuration
Table 9-3 Import/Export Configurations
Parameter Function
Import Click to import local setup files to the system.
Export Click to export the current system setup to your local PC.

Honeywell H4W2PER3 Specifications

General

Brand	Honeywell
Model	H4W2PER3
Category	Security Camera
Language	English