Honeywell L5200 Series Installation And Setup Guide

LYNX Touch Installation and Setup Guide
- 15 -
Installing/Configuring Communication & Home Automation Modules
7000-100-014-V0
REMOVE ILP5
SPACER
REMOVE ILP5
KNOCKOUT
SCREW
(3)
ROTATED
180
CONNECTOR
BOARD
CONNECTOR BOARD
RECEPTACLE
ILP5
LYNX TOUCH
L7000
TIE
WRAP
POINT
ILP5 SPACER
TIE
WRAP
(1)
TO ILP5
LYNX TOUCH
ALTERNATE INSTALLATION
RJ45
RECEPTACLE
RJ45 RECEPTACLE
ETHERNET CABLE
L7000 IP Communications Module Installation
Installing the L5100-WiFi module

Do not install the L5100-WiFi if the ILP5 Ethernet communications module is being installed.
1. Install the L5100-WiFi into the LYNX Touch control front case as shown below. Ensure that the receptacle is properly
seated into the edge connector on the right (speaker) side of the control’s circuit board.
2. Enable the L5100-WiFi module, configure alarm reporting and module supervision and register the device. Refer to the
“Program the Communications Module” and “Communications Diagnostics” sections.
The communications module must be registered with AlarmNet before downloading or alarm reporting can
take place.
Installing the L5100-ZWAVE Home Automation module
1. Enable the L5100-ZWAVE module. Refer to the “Program the Z-Wave Module”.
2. Install the L5100-ZWAVE into the LYNX Touch control front case as shown below. Ensure that the receptacle is properly
seated into the edge connector on the left (TELCO terminal) side of the control’s circuit board.

Honeywell L5200 Series Specifications

General

Brand	Honeywell
Model	L5200 Series
Category	Security System
Language	English