Honeywell L5200 Series User Manual

– 27 –
SECURING THE PREMISES
Disarming the System
When an Alarm Occurs
When an alarm has occurred, the touch screen displays the zone number(s) that caused the alarm and the type
of alarm (e.g., “Fire Alarm”). These messages remain displayed until cleared by a user. To clear the display,
note the zone number that is displayed and enter an Off sequence. If the fault cannot be corrected, notify your
alarm company.
Disarming the System and Silencing Alarms
Alarm
Enter Code:
Cancel
2 31
564
0
8 97
Clear
5200-100-088-V0
Alarm 2 Front
Door
1. Enter a valid Code. The system beeps once and announces
“Disarmed Ready to Arm”.
Note: If a valid user code is not entered before the programmed
entry delay occurs, the system remains in alarm mode.
Alarm Cancel
5200-100-089-V0
Alarm 2 Front
Door
Phone
More
Message
Zones
Disarm
4:43 PM August 11, 2011
System
2. “Alarm Cancel” is displayed in a red band along with the zone
that caused the alarm. Select the “Disarm” icon and enter a
second Off sequence to clear the alarm. The system beeps
once, returns to the Security Screen and announces
“Disarmed Ready to Arm”.

Honeywell L5200 Series Specifications

General

Brand	Honeywell
Model	L5200 Series
Category	Security System
Language	English