Honeywell L5200 Series User Manual

– 38 –
USER FUNCTIONS
Message Recording and Playback
The LYNX Touch Message Center allows you to record, play and delete messages. The maximum message
duration is 184 seconds.
NOTES: (1) If the system loses electrical power, all messages will be erased.
(2) Message Play/Record will not be available if a report must be sent.
Entering Message Mode
Ready To Arm
5200-100-014-V0
Arm Away
Delay
Phone
More
Message
System
Arm Stay
10:18 AM June 8, 2010
Zones
1. With the system in the disarmed state, select the “Message”
icon from the Security Screen. The system displays the
Message screen.
Recording a Message
Ready To Arm
Save
5200-100-045-V0
No items to display!
Add New
Delete All
Play
1. Select “Add New”. The system displays the Record Message
screen.
Note: The System will display the total message recording time
available.
Ready To Arm
5200-100-046-V0
Time Remaining : 184 Seconds
Message 1 Stopped
Record DeletePlay
2. Select “Record”, the system sounds a single tone. Speak into
the microphone and record your message.
3. When you are finished recording your message, select. “Stop”
4. To listen to the message, select “Play”.
5. If you wish to delete the message, select “Delete”.
6. Record additional messages as required.
5200-100-047-V0
Message 1 2:48 PM September 1, 2010
Message 2 5:09 PM September 5, 2010
Add New Delete AllPlay
Ready To Arm
6. When you have finished recording, select “”. The system
displays the recorded messages.
7. To record additional messages (if recording time is available)
repeat steps 1 through 3.
NOTE: If you are trying to record a new message and the message center is already full, “Add New” will not be displayed. If the
message center is full all old messages must be deleted before new messages can be recorded. See the Deleting
Messages section.

Honeywell L5200 Series Specifications

General

Brand	Honeywell
Model	L5200 Series
Category	Security System
Language	English