Honeywell RTU A08 User Manual

20 TK_S014 – Installation Manual
ACTIVATION
This chapter shows only the preliminary steps required for the RTU activation.
The complete configuration of the device is beyond the scope of this manual; please refer to EBI Temaline
Interface - Temaline Access Control Configuration Guide for further details on these activities.
Checking the communication between RTUA08 and TemaServer
To do this verification procedure it is required to:
• Have the RTU A08 wired with the TemaServer device that manages it through the Lonwork wire.
• RTU A08 powered and working
• The TemaServer powered and working
To check the RTU A08 communication, you can activate the device service pin using the button located
inside the module.
To do this, follow these steps:
1. Push the internal «service» button
2. The TemaServer will send a wink, in response to the service pin that will cause the yellow Led to
remain illuminated for a couple of seconds. This allows you to verify that communication to and from
the TemaServer is operational
3. Make sure that the yellow service LED is off at the end of the operation.
SERVICE-LED
SERVICE-REED
SERVICE-BUTTON
Figure 13. RTUA08 Service Elements

Honeywell RTU A08 Specifications

General

Brand	Honeywell
Model	RTU A08
Category	Control Unit
Language	English