– 28 –
Checking For Open Zones
Using the ✴
✴✴
✴
READY Key
Before arming your system, all protected doors, windows and other protection
zones must be closed or bypassed (see BYPASSING section). Otherwise the
keypad will display a "Not Ready" message. Using the READY key will
display all zones that are faulted, making it easier for you to secure any open
zones.
To show faulted zones:
DISARMED - PRESS
T TO SHOW FAULTS
NOTE: Some keypads light a green LED when
the system is ready. If not lit, the system is not
ready to be armed.
READY
1. Do not enter security code, but simply press ✴ .
FAULT 005 FRONT
UPSTAIRS BEDROOM
Typical fault display
DISARMED
READY TO ARM
Secure or bypass the zones displayed before
arming the system. The "Ready" message will
be displayed
†
when all protection zones have
been either closed or bypassed.
†
NOTE: All or part of this message may be
replaced by a customized message programmed
by the installer. Bear this in mind whenever
the instructions indicate that the
"DISARMED" or "READY" message will be
displayed.
To Next Page
Loading...
Need help?
General
