– 45 –
Using #70 Relay Menu Mode
General Information
Your system may be set up so that certain lights or other devices can be
turned on or off by using the #70 command from a keypad. Ask your installer
if this has been done in your system.
To activate relays from a keypad, enter 4-digit security code + [#] +70.
Follow the keypad prompts described below.
NOTE: Your installer may have restricted the use of this function. Please
check with your installer.
ENTER DEVICE NO.
00=QUIT 01
Enter the 2-digit number of the device to be
activated.
Note that if an invalid number is entered, the
system will simply ask you to reenter the number.
NN DEVICE IS OFF
HIT 0=OFF , 1=ON
Press 0 or 1 to turn the device off or on respectively.
"nn" represents the 2-digit device number and voice
descriptor is the relay voice descriptor programmed
by the installer.
NN DEVICE IS OFF
HIT THE "✴" KEY
From a keypad, press ✴ to continue. The ENTER
DEVICE NO. prompt will appear.
To Next Page
Loading...
Need help?
General
