– 32 –
Bypassing Protection Zones (cont’d)
To use the Group Bypass feature:
BYPASS
1. Enter your security code and press 6 then press ✳ then enter the
group number (01-15).
2.
BYPASS 007 FRONT
UPSTAIRS BEDROOM
Typical bypass message
In a few moments, all the zones in the group
will be displayed along with the word BYPASS.
Wait for these zones to be displayed before
arming. Arming the system before bypassed
zones are displayed eliminates all bypasses.
3.
DISARMED BYPASS
READY TO ARM
Arm the system as usual when the keypad
displays the "ready" to arm message. Bypassed
zones are unprotected and will not cause an
alarm when violated while your system is
armed.
Zones Remaining Bypassed After Disarming
The system provides an option to allow all manually bypassed zones to remain
bypassed upon disarming (security code + OFF) of the partition. This option must be
programmed by your installer. Check with your installer to see if this option has been
enabled.
NOTES:
For each partition in which the option is enabled, the security code + OFF will no
longer unbypass zones. To unbypass ALL zones you must enter your security code + #
+ 64. To unbypass zones INDIVIDUALLY, you must enter your security code + 6 +
zone number.
Any zone that was automatically bypassed by the system will be unbypassed upon
disarming the system (e.g. STAY mode, Auto-STAY, etc.).
Vent zones and zones bypassed by a programmed Auto-Bypass schedule (Tme Driven
Event) are considered “manual bypasses” and will not be unbypassed upon disarming
the system.
Zones that were in a bypassed state at the time a System Shutdown is sent from the
Compass Downloading software will be unbypassed when the System Shutdown is
removed.
To Next Page
Loading...
Need help?
General
