To Next Page

To Previous Page

Device Settings

The basic function parameters for the X-DCS3000 can be set under this tab. These items such as

Properties, Modules, Amplifier, Time, Supervision, and AVC will be set in turn.

1． Properties

“Properties” is used to set the requisite parameters for the X-DCS3000, as shown below：

 Basic Setting

Basic Setting includes Device ID, Device Name, Device Type, Emergency Button and Emergency

Buzzer. Device ID is the only device identification in the system, which in the range of 1~999.

The option “Emergency Button” is to enable or disable emergency button on X-DCS3000 front

panel. The checkbox shown as means enabled.

 Integration Interface

This item is used to set the interface type, which includes Disabled and Dry Contact. The default

setting is disabled.

 Network Setting

Use to set the X-DCS3000 network parameter. Old IP is the IP address before setting, and New IP

is the IP address after setting. For updating the network parameters of the system devices, it shall

be connected to computer whose IP should be in the same segment with the old IP of DCS. Click

the Update button for setting the IP of DCS, the two IP address would be the same after updating

successfully. The default IP address is 192.168.2.200. If the specified IP address has been

forgotten, the default IP address can be obtained by pressing the appropriate button to reset the IP

address.

Note: Network parameter is excluded in configuration files. Downloading configuration won’t

change network configuration, which can be only changed by updating. While operating, please

make sure device is connected to the network and the network settings are correct.

 Zone List

The Zone List setting function allows users to enable/disable the zones and set the Zone Name

and Power. Check the check box shown as to enable the corresponding zone.

And shows the zone is disabled. Click directly one zone name or power in the zone list to edit

it. The power setting value is only used to determine if the amplifiers are appropriate. The output

Honeywell X-DCS3000 User Manual

Other manuals for Honeywell X-DCS3000