8
3 Basic Operations
This chapter describes the basic operations of the X-618 Config software.
Running the Software
Note:
Make sure X-SMART software and the X-618 Config software are not running at the same time.
If the X-SMART software is running, the X-618 Contig software cannot be run.
The steps for running the software are as follows:
1. Click Start at the lower left of your computer desktop, and select Program
X-618 Config
X-
618 Config.
2. Select the menu commands Tools
Select Language, the Select Language window is
displayed. The user can select the appropriate language. Click OK. The main window which is
shown in English is displayed as shown in Figure 3.
Figure 3 X-618 Config Software Initial Window
Exiting the Software
Select the menu commands Project
Exit or click the “X” icon on the upper right corner, a prompt
dialogue displays. Click Yes in this prompt dialogue to exit the software.
To Next Page
Loading...
Need help?
General