To Next Page

To Previous Page

13-13

Configuring Port-Based and User-Based Access Control (802.1X)

General Setup Procedure for 802.1X Access Control

General Setup Procedure for 802.1X

Access Control

Do These Steps Before You Configure 802.1X Operation

1. Configure a local username and password on the switch for both the

Operator (login) and Manager (enable) access levels. (While this may or

may not be required for your 802.1X configuration, HP recommends that

you use a local username and password pair at least until your other

security measures are in place.)

2. Enable include-credentials. The port-access option is available only if

include-credentials is enabled. See “Saving Security Credentials in a Config

File” on page 2-11 in this guide.

For switches covered in this guide, the local operator password config-

ured with the password command is not accepted as an 802.1X authenti-

cator credential. The port-access command is used to configure the

operator username and password that are used as 802.1X credentials for

network access to the switch. 802.1X network access is not allowed unless

a password has been configured using the password port-access command.

Syntax: password port-access [user-name <name>] <password >

Configures the operator username and password

used to access the network through 802.1X

authentication.

user-name <name>

Operator username (text string) used only for

local authentication of 802.1X clients. This

value is different from the local operator user-

name configured with the password command

for management access.

Operator password (text string) used only for

local authentication of 802.1X clients. This

value is different from the local operator pass-

word configured with the password command

for management access.

Other manuals for HP 3500yl Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500yl Series and is the answer not in the manual?

General