HP 4262A User Manual

Section 1
Table 1-1
Model 4262A
Table 1-1. Specifications (Sheet 1 of 4).
COMMON SPECIFICATIONS
Parameters Measured: C - D or Q (1/D)
L-DorQ(1/D)
R (ESR) (Loss measure-
ment can be negated by
switch on internal board).
Display: 3-1/2 Digit, Maximum Display 1999
(When D value is more than 10, max-
mum display is 199).
Measurement Circuit Modes:
Auto, Parallel, and Series
Measurement Terminals: 5-terminal configura-
tion (high and low terminals for both
potential and current leads plus guard).
Range Modes: LCR - Auto and Manual
(up-down)
Deviation Measurement: When 2ALCR key is de-
pressed, the existing measured value
is stored as a reference value and
displayed value is offset to zero. The
range is held and deviation is dis-
played as the difference between the
referenced value and subsequent re-
sult. (Deviation spread in counts
from -999 to 1999).
Offset Adjustment: Stray capacitance and re-
sidual inductance of test jig can be
compensated for as follows:
C: up to 10pF
L: up to 1uH
Self Test: Annunciates either Pass, or Fail for
performance in each of the five basic
DQ - Auto and Manual (step) ranges.
DC Bias:
Measurement Frequencies: 120(100)Hz, 1kHz Internal: 1.6V, 2.2V, 6V (Selectable at front
and 10kHz 1+3%. panel). Accuracy £5%
External: External DC bias connector on rear
panel. Maximum +40V.
Test Signal Level: Normal level: 1Vrms.
Low level : 50mVrms (parallel Trigger: Internal, External, or Manual
capacitance mode only)
Warm-up Time: 15 minutes
GENERAL
Operating Temperature & Humidity:
0°C to 55°C at 95% RH(to 40°C)
Power Requirements: 100/120/220V +10%,
240V +5% -10% 48 - 66Hz
Power Consumption: 55VA with any option
Dimensions: 426(W) x 147(H) x 345(D)mm
(16-3/4° x 5-3/4” x 13-3/4”)
Weight: Approximately 8kg (Std)
1-2

HP 4262A Specifications

General

Brand	HP
Model	4262A
Category	Measuring Instruments
Language	English