1-3
HP 8719/20/22ES Specifications and Characteristics
Corrected System Performance (HP 8719/20ES)
Corrected System Performance (HP 8719/20ES)
The specifications in this section apply for measurements made using 10 Hz IF bandwidth,
no averaging, and at an environmental temperature of 23 ±3 °C, with less than 1 °C
deviation from the calibration temperature. Assumes that an isolation calibration was
performed with an averaging factor of 8.
Table 1-1 System Dynamic Range, All Device Connector Types
HP 8719/20ES, All Cal Kits, All Cables, 10 Hz IF BW
Description Specification Supplemental
Information
System Transmission Dynamic Range
HP 8719/20ES (Standard)
a
a. The System Transmission Dynamic Range is calculated as the difference
between the receiver noise floor and the lesser of either: the source maximum
output or the receiver maximum input. The receiver noise floor is specified as 3
standard deviations above the mean of the linear magnitude noise floor trace
over the specified frequency band.
50 MHz to 840 MHz 77 dB
840 MHz to 8 GHz 100 dB
8 GHz to 20 GHz 100 dB
HP 8719/20ES (Option 007)
a
50 MHz to 840 MHz 82 dB
840 MHz to 20 GHz 105 dB
HP 8719/20ES (Option 012 with test set bypassed)
b
b. The System Transmission Dynamic Range is calculated as the difference
between the receiver noise floor and the lesser of either: the source maximum
output or the receiver maximum input. The receiver noise floor is specified as
the mean of the linear magnitude noise floor trace over the specified frequency
band.
50 MHz to 500 MHz 115 dB, typ.
500 MHz to 2 GHz 115 dB, typ.
2 GHz to 8 GHz 115 dB, typ.
8 GHz to 13.5 GHz 113 dB, typ.
13.5 GHz to 20 GHz 113 dB, typ.
To Next Page
Loading...
Need help?
General
