18. A prompt is displayed with a message directing you to insert the Linux installer media in
the CD or DVD drive, as shown in Figure 3-13.
IMPORTANT: If you are using a serial console, prior to starting the Linux OS Installation,
see “Configuring and Using a Serial Console” (page 51) and follow the instructions.
Figure 3-13 Inserting the Linux Installer Media
Insert the Linux Installer media and press Enter.
The Linux OS installation completes. Immediately after the initial installation of the OS is
successfully installed, HP recommends that you run the HP Support Pack installer as described
in Chapter 5 (page 41).
Using the Linux Media to Install the OS
You can install Linux on your server using the distribution media for one of the supported OSs.
This activity is considered a “cold installation”. The installation process is very similar to the
standard cold installation with these three configuration exceptions:
• Firewall configuration
• Security Enhanced Linux (SELinux)
• Package group selection
The instructions for the supported OSs are detailed in the following documents:
• For RHEL4— See Red Hat Enterprise Linux 4 Installation Guide for x86, Itanium, AMD64, and
Intel Extended Memory 64 Technology (Intel EM64T):
http://www.redhat.com/docs/manuals/enterprise/RHEL-4-Manual/x8664-multi-install-guide/
• For RHEL5— See Red Hat Enterprise Linux 5 Installation Guide):
http://www.redhat.com/docs/manuals/enterprise/RHEL-5-manual/Installation_Guide-en-US/
• For SLES10— See Installing SUSE LINUX Enterprise Server 10 on HP Integrity Servers:
http://docs.hp.com/en/5991-6394/
• For SLES11— See Installing SUSE LINUX Enterprise Server 11 on HP Integrity Servers:
http://docs.hp.com/
32 Installing the OS and Updating the Server
To Next Page
Loading...
Need help?
General