1. Start the installer:
# ./install.sh
The following message is displayed:
Welcome to the HP Insight Foundation suite for Integrity with Linux version *.**.
For the latest information and downloads go to http://www.hp.com/go/integritylinuxessentials.
Press <enter> to continue the installation of the current version of the HP Support Pack.
2. You are prompted to make additional selections based on the software update option you
selected in the previous step.
The installer analyzes your system and prepares it for installation of the products provided
with the HP Support Pack.
NOTE: If the installer detects missing RPMs that are necessary to the installation, messages
are displayed indicating which RPMs you must install before proceeding. For example,
messages similar to the following may appear:
hpima will not be available because the following required RPMs are missing:
net-snmp sensors
hpsmh will not be available because the following required RPMs are missing:
net-snmp sensors
In this case, you would need to install the required RPMs for HP-IMA and HP SMH before
these products can be installed.
NOTE: If the installer detects missing JAVA or JAVA not configured, messages are displayed
indicating which RPMS you can not install. For example, messages similar to the following
may appear:
hpsmh-tomcat cannot be installed because Java not installed
hp.com-parmgr cannot be installed because Java not installed
The nPartition Management GUI for HP Integrity servers. cannot be installed for the following reasons:
The following IFIL dependencies have been excluded: hpsmh-tomcat hp.com-parmgr
In this case, you would need to install JAVA and configure JAVA for hpsmh-tomcat and
hp.com-parmgr.
A menu of available products and options that can be installed is displayed. The contents
of this menu depend upon the version of the HP Support Pack that you are installing or the
Linux distribution installed on your system. A menu similar to one of the following is
displayed:
Menu for RHEL4: 1. Install HP Utilization WBEM Provider
2. Install HP Management Base for Integrity and
Proliant Servers
3. Install HP System Management Homepage
4. Install MPT Fusion SAS Integrated RAID
configuration utility
5. Install The Open64 Compiler Suite v4.2.1
6. Install HP Command Line Array Configuration
Utility
7. Install HPVM Guest Kit for Linux
8. Install HP Insight Manager Agents (SNMP) for
HP Integrity servers
9. Install HP Insight Manager Agents Webapp via
HP SMH.
10. Install nPartition Commands
11. Install The nPartition Management GUI for HP
Integrity servers.
12. Install HP WBEM Providers for Linux
13. Install Everything
14. Uninstall IFIL and return to this menu
15. Exit
Installing Software from the HP Support Pack 47
To Next Page
Loading...
Need help?
General