2–6 336493-004 Service Reference Guide, d200
Setup Utilities and Diagnostics Features
Power
Management
Setup
(Continued)
Resume on LAN
(d220, d228, and
d230 models only)
Sets the Resume On LAN from soft off.
• Disable: LAN Resume disable
• Enable: LAN Resume enable (default)
Resume on PME Sets the Resume On PME from soft on.
• Disable: PME Resume disable
• Enable: PME Resume enable (default)
Peripheral
Setup
OnBoard LAN Enables or disables the OnBoard LAN.
• Disable: OnBoard LAN disabled
• Enable: OnBoard LAN enabled (default)
OnBoard LAN
Chip Boot ROM
Enables or disables the OnBoard LAN Chip Boot ROM.
• Disable: OnBoard LAN Chip Boot ROM disabled
• Enable: OnBoard LAN Chip Boot ROM enabled (default)
Init. Graphics
Adapter Priority
Sets the initial priority of the graphics adapter
NR 138 GE (d220, d228)
•AGP/Int-VGA
• AGP/PCI (default)
•PCI/AGP
•PCI/Int-VGA
NR 138 GV (d230)
•PCI/Int-VGA (default)
NR 146 GV (d240, d248)
•PCI/Int-VGA (default)
•Int-VGA/PCI
USB Controller Enables or disables the USB controller.
• Disable: USB controller disabled
• Enable: USB controller enabled (default)
USB 1.1 Device
Legacy Support
Sets the USB 1.1 Device Legacy Support under DOS mode.
• Disable: USB 1.1 Device Legacy Support disabled
• No Mice: A mouse is not supported
• All Devices: All devices are supported (default)
OnBoard Serial
Port
Sets the OnBoard Serial Port settings
•Auto (default)
•Disable
•3F8/COM1
•2F8/COM2
•3E8/COM3
•2E8/COM4
✎
Support for Computer Setup options may vary depending on your specific hardware configuration.
Heading Option Description
To Next Page
Loading...
Need help?
General