HP Compaq Elite 8300 Series User Manual

Removing a Bezel Blank
On some models, there is a bezel blank covering the internal drive bay that needs to be removed
before installing a drive. To remove a bezel blank:
1. Remove the access panel and front bezel.
2. To remove the bezel blank, push the two retaining tabs that hold the bezel blank in place
towards the outer left edge of the bezel (1) and pull the bezel blank inwards to remove it (2).
Figure 5-5 Removing a Bezel Blank
Replacing the Front Bezel
Insert the three hooks on the bottom side of the bezel into the rectangular holes on the chassis (1)
then rotate the top side of the bezel onto the chassis (2) and snap it into place.
Figure 5-6 Replacing the Front Bezel
Removing a Bezel Blank 133

HP Compaq Elite 8300 Series Specifications

General

Brand	HP
Model	Compaq Elite 8300 Series
Category	Desktop
Language	English