Figure 4 Rear view of the HP D2D2502/2504 G2
5. PCIe slots (one full and one low profile)1. Power supply cable socket
6. VGA port for system console monitor2. LAN port 1 (always used for data connection)
7. USB ports for system console keyboard and mouse3. LAN port 2
4. iLO2 Management port (Do not use for data)
Using the ProLiant Guide with HP D2D4112 G1 models
When using the HP ProLiant DL185 G5 guide, be aware of the following HP D2D-specific
information:
• The system components are illustrated in the 12HDD server diagram and the Opteron 2384,
part number 495643-005, is the only processor that is supported.
• The HP D2D has 12 removable hard disks. The 12th disk is an online spare disk. If one of
the other disks fails, the online spare disk immediately takes its place.
• There is no optical media storage.
• The configuration of the system memory is 16 GB (8 x 2 GB DIMMs). The part number for
each 2 GB DIMM is 499276-061.
• The HP D2D is supplied with an HP Smart Array P800 controller (with 512 MB and two
BBWCs) pre-installed in one of the full-height PCI-e slots. For more information about this card,
search on http://www.hp.com/support/manuals. Part numbers are as follows:
◦ P800 card: 398647–001
◦ 512 MB memory: 398645–001
◦ BBWC: 398648–001
• The system has an HP StorageWorks Dual Channel 4Gb PCIe Fibre Channel Host Bus Adapter,
part number AE312A
10 Introduction
To Next Page
Loading...
Need help?
General