Updating the docking station
Downloading HP Firmware Installer
1. Go to http://www.hp.com/support.
2. Select Get software and drivers, and follow the on-screen instructions to nd your docking station.
3. Follow the on-screen instructions to select and download HP Firmware Installer.
4. Complete the installation wizard.
5. Choose to restart now or later. The docking station might not work until the next restart. If you choose
to restart the computer, rst remove any discs from the computer drives. Click Finish.
Installing updates
You can update the docking station while connected to your computer or, for better performance, schedule
the docking station to update when you disconnect your computer from the docking station.
1. Open Windows Explorer and navigate to where you saved HP Firmware Installer.
2. Double-click HPFirmwareInstaller.exe.
3. Verify that updates are available, and then select which updates to Install.
TIP: You must be connected to the Internet for new updates to download to HP Firmware Installer.
4. Select one of the following:
● Update now: Installs the update immediately.
NOTE: You cannot disconnect your computer from the docking station during an update.
Your might see your monitor icker and hear some audio clicks, your Internet connection might be
intermittent, and your mouse and keyboard could become unresponsive until installation is
complete.
● Update on dock disconnect: Installs the update after you disconnect your computer from the
docking station.
NOTE: You cannot connect your computer to the docking station during an update.
The dock power light might blink while the update is being installed.
5. Select Install.
Updating the docking station 9
To Next Page
Loading...
Need help?
General
