HP ProCurve 2810 Series Access Security Guide

1-9
Getting Started
Need Only a Quick Start?
To Set Up and Install the Switch in Your Network
Important! Use the Quick Installation Guide shipped with your switch for the following:
■ Notes, cautions, and warnings related to installing and using the
switch
■ Instructions for physically installing the switch in your network
■ Quickly assigning an IP address and subnet mask, setting a Manager
password, and (optionally) configuring other basic features.
■ Interpreting LED behavior.
For the latest version of the Installation and Getting Started Guide and other
documentation for your switch, visit the ProCurve Networking Web site.
(Refer to “Product Documentation” on page xi of this guide for further
details.)

HP ProCurve 2810 Series Specifications

General

Jumbo Frame Support	Yes
Model	HP ProCurve 2810 Series
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 SFP (mini-GBIC) slots
Forwarding Rate	71.4 Mpps
Layer	Layer 2
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static IP routing
Form Factor	Rack-mountable
Power Consumption	48W (24-port)
Operating Temperature	32°F to 0°F (0°C to 0°C)
Operating Humidity	15% to 95% non-condensing
Power Supply	Internal power supply