HP ProCurve 2810 Series Access Security Guide

2-17
Configuring Username and Password Security
Front-Panel Security
Figure 2-11. Example of the Steps for Disabling Password-Recovery
Password Recovery Process
If you have lost the switch’s manager username/password, but password-
recovery is enabled, then you can use the Password Recovery Process to gain
management access to the switch with an alternate password supplied by
ProCurve.
Note If you have disabled password-recovery, which locks out the ability to recover
a manager username/password pair on the switch, then the only way to
recover from a lost manager username/password pair is to use the
Reset+Clear button combination described under “Restoring the Factory
Default Configuration” on page 2-9. This can disrupt network operation and
make it necessary to temporarily disconnect the switch from the network to
prevent unauthorized access and other problems while it is being reconfig-
ured.
To use the password-recovery option to recover a lost password:
1. Note the switch’s base MAC address. It is shown on the label located on
the upper right front corner of the switch.
2. Contact your ProCurve Customer Care Center for further assistance.
Using the switch’s MAC address, the ProCurve Customer Care Center will
generate and provide a “one-time use” alternate password you can use
with the to gain management access to the switch. Once you gain access,
you can configure a new, known password.

HP ProCurve 2810 Series Specifications

General

Brand	HP
Model	ProCurve 2810 Series
Category	Switch
Language	English