HP t510 User Manual

2 Hardware Changes
General Hardware Installation Sequence
To ensure the proper installation thin client hardware components:
1. Back up any data, if necessary.
2. If the thin client is powered on:
a. Turn off the computer properly through the operating system, then turn off any external
devices.
b. Disconnect the power cord from the power outlet and disconnect any external devices.
c. Disconnect any external devices or cables, such as an antenna or cable lock.
WARNING! To reduce the risk of personal injury from electrical shock and/or hot surfaces, be
sure to disconnect the power cord from the wall outlet and allow the internal system components to
cool before touching.
WARNING! To reduce the risk of electrical shock, fire, or damage to the equipment, do not
plug telecommunications or telephone connectors into the network interface controller (NIC)
receptacles.
CAUTION: Static electricity can damage the electronic components of the thin client or optional
equipment. Before beginning these procedures, ensure that you are discharged of static electricity
by briefly touching a grounded metal object. See
Electrostatic Discharge on page 31 for more
information.
3. Remove the secure USB compartment cover. See Removing and Replacing the Secure USB
Compartment Cover on page 11 for more information.
4. Remove the stand, if it is installed. See
Removing the Stand on page 6 for more information.
5. Remove the side access panel and metal side cover. See
Removing and Replacing the Side Access
Panel and Metal Side Cover on page 12 for more information.
6. Remove any hardware that you will replace.
7. Install or replace equipment. For removal and replacement procedures, see the following sections:
●
Installing the USB Device on page 15
●
Removing and Replacing the Battery on page 16
●
Installing a Secondary Flash Memory Module on page 18
NOTE: Option kits include more detailed installation instructions.
8. Replace the side access panel and metal side cover. See Removing and Replacing the Side
Access Panel and Metal Side Cover on page 12.
10 Chapter 2 Hardware Changes

HP t510 Specifications

General

Processor cores	2
Processor model	U4200
Processor family	VIA Eden
Motherboard chipset	VIA VX900
Processor frequency	1 GHz
Storage media	Flash
Card reader integrated	No
Total storage capacity	1 GB
Internal memory	2 GB
Memory clock speed	1066 MHz
Internal memory type	DDR3-SDRAM
Graphics card	Chromotion HD 2.0
Networking features	Gigabit Ethernet
Graphics card family	VIA
Dimensions (W x D x H) with stand	58.4 x 215.9 x 219.7 mm
Wi-Fi	Yes
Wi-Fi standards	802.11a, 802.11b, 802.11g
Cabling technology	10/100/1000Base-T(X)
USB 2.0 ports quantity	6
Ethernet LAN (RJ-45) ports	1
VGA (D-Sub) ports quantity	0
Operating system installed	-
Power supply	65 W
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Audio system	24-bit
Sustainability certificates	ENERGY STAR
Product color	Black
Country of origin	China

Weight and Dimensions

Depth	215.9 mm
Width	58.4 mm
Height	209 mm
Weight	1490 g