HP t630 Thin Client User Manual

NOTE: An optional Quick Release mounting bracket is available from HP for mounting the thin client to a wall,
desk, or swing arm. When the mounting bracket is used, do not install the thin client with the I/O ports oriented
towards the ground.
Connecting the AC power cord
1. Connect the round end of the power supply cord to the power supply connector on the rear of the thin
client (1).
2. Use the slot (2) on the side of the retractable AC power cord retention hook to pull the hook out.
3. Press the AC power cord into the retention hook (3) and bundle any excess AC power cord.
4. Plug the female end of the AC power cord into the power supply brick (4).
5. Connect the other end of the AC power cord to an AC outlet (5).
CAUTION: Failure to secure the power cable with the retention hook may result in the AC power cord becoming
disconnected, causing loss of data.
8 Chapter 2 Setup

HP t630 Thin Client Specifications

General

Brand	HP
Model	t630 Thin Client
Category	Desktop
Language	English