HP t730 Thin Client User Manual

Computer Setup—Security
NOTE: Support for specic Computer Setup options may vary depending on the hardware conguration.
Table A-1 Computer Setup—Security
Option Description
Setup Password Allows you to set and enable a setup (administrator) password.
NOTE: If the setup password is set, it is required to change Computer Setup options, ash the ROM, and
make changes to certain plug and play settings under Windows.
Power-On Password Allows you to set and enable a power-on password. The power-on password prompt appears after a
power cycle or reboot. If the user does not enter the correct power-on password, the unit will not boot.
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Allows you to enable/disable:
●
Stringent Password – When set, enables a mode in which there is no physical bypass of the
password function. If enabled, removing the password jumper will be ignored.
●
Password Prompt on F9 & F12 – Default is enabled.
●
Setup Browse Mode – Allows viewing, but not changing, the F10 Setup Options without entering
setup password). Default is enabled.
Device Security Allows you to set Device Available/Device Hidden (default is ‘Device Available’) for:
●
Embedded Security Device
●
System audio
●
Network controller
●
SATA Port 0
USB Security Allows you to set Enabled/Disabled (default is enabled) for:
●
Front USB Ports
—
USB Port 4
—
USB Port 5
—
USB Port 10
—
USB Port 11
●
Rear USB Ports
—
USB Port 0
—
USB Port 1
—
USB Port 2
—
USB Port 3
●
Accessory USB Ports
—
USB Port 12
Slot Security Allows you to disable the PCI Express slot and Mini Card Slot. Default is enabled.
●
PCI Express x8 Slot 1
●
M.2 PCIe x1
Network Boot Enables/disables the computer’s ability to boot from an operating system installed on a network server.
(Feature available on NIC models only; the network controller must be either a PCI expansion card or
embedded on the system board.) Default is enabled.
26 Appendix A Computer Setup (F10) Utility, BIOS Settings

HP t730 Thin Client Specifications

General

Memory	Up to 16 GB DDR3L-1600 SDRAM
Graphics	AMD Radeon R7E
Networking	Optional Wi-Fi
Ports	1 x RJ-45
Operating System	Windows 10 IoT Enterprise
Weight	1.3 kg
Power Supply	65W external power adapter

Summary

2 Hardware Changes and Upgrades

Critical Safety Warnings

Essential safety precautions and warnings to prevent injury or damage before hardware tasks.

Access Panel Removal and Replacement

Step-by-step guide to safely access the internal components by removing the access panel.

Internal Component Location Guide

M.2 Flash Storage Module Service

Procedures for the removal and installation of the M.2 flash storage module.

Internal Battery Replacement Procedure

Detailed instructions for replacing the thin client's internal battery.

PCI-Express Card Installation Guide

WLAN Module Replacement Guide

Internal USB Flash Drive Installation

SDRAM System Memory Upgrade

Steps for enhancing performance by adding or replacing system memory (SODIMMs).

Appendix A BIOS Configuration and Utilities

Computer Setup (F10) Utility Overview

Explains the overall capabilities and functions of the Computer Setup (F10) Utility.

Accessing and Navigating Computer Setup

Step-by-step instructions for entering and using the Computer Setup utility interface.

Computer Setup - Security Settings

Security features including passwords, device access control, USB security, and secure boot.

Updating and Restoring System BIOS

Procedures for updating or restoring the system BIOS firmware.

Appendix B Diagnostics and Troubleshooting

Power-On Sequence and Diagnostics

Password Reset Procedures

Critical steps to reset forgotten Setup and Power-on passwords.

Power-On Diagnostic Tests Explained

Interpreting POST LEDs and Audible Codes

How to interpret front panel LED and audible codes during Power-On Self-Test (POST).

POST Numeric Codes and Text Messages

Explanations for POST errors identified by numeric codes and text messages.

Diskless Unit Troubleshooting Guide

Appendix C HP ThinUpdate Image Restore

HP ThinUpdate Feature Overview

Image Restore System Requirements

Appendix D Device Management

HP Device Manager Usage

Appendix E Adding an Image Restore Tool

Image Restore Tool Setup Steps