FusionModule5000 Smart Modular Data Center
Product Description (ECC800)
PWR_IN D-type power input terminal, for power cascading, input voltage
range: 45–55 V DC
⚫
PWR_OUT D-type power output terminal, for power cascading, output
voltage range: 45–55 V DC
⚫
48V_OUT1 and 48V_OUT2, phoenix terminal, output voltage range:
45–55 V DC
Two FE ports, RJ45 terminal with an indicator, 10/100M communication
rate, for the cascading between smart ETH gateways and the
communication with the upper computer
Four PoE ports, RJ45 terminal with an indicator, 10/100M
communications rate, 45–55 V DC of power output, complying with
IEEE802.3at
If you press the BLINK button once, the RUN indicator blinks
intermittently at super short intervals (blinking at super short intervals for
0.5s and then off for 0.5s) for 10 seconds. This indicates that the smart
ETH gateway reports the Media Access Control (MAC) address and
equipment serial number (ESN) to the ECC800.
Indicators
Table 3-64 describes the indicators on a smart ETH gateway.
Table 3-64 Indicators on a smart ETH gateway
Power input
status indicator
The power input is normal.
Module
running status
indicator
The power supply is abnormal.
Blinking at
long intervals
The smart ETH gateway
successfully registers with the
ECC800 and the software runs
properly (the indicator blinks at 0.5
Hz, on for 1s and then off for 1s).
Blinking at
short intervals
The smart ETH gateway does not
register with the ECC800 (the
indicator blinks at 4 Hz, on for
0.125s and then off for 0.125s).
The indicator blinks at super short
intervals for 0.5s (blinking at 10 Hz,
on for 0.05s and then off for 0.05s)
and then turns off for 0.5s. The
cycle lasts for 10s.
To Next Page
Loading...
Need help?
General
